This web site has illustrated repair guidesĪnd there are also numerous YouTube videos on taking iPods apart. I have plenty of "spare parts" for my 4th gen iPod. As expected, it had a bad hard drive, and everything else was in good shape. I recently bought a broken 4th gen for less than $5 (including shipping). If other parts wear out, go on eBay and buy broken iPods. And they're still fast compared to the pokey 1.8-inch hard drive. The fast CF cards are still expensive, but for use in an iPod, slower is fine, because the slower ones use less energy. Much less than the price for any "8th gen" ipod classic that Apple could possibly create. This web site has cool info about doing the same thing with 5th gen and later.ĬF card prices are already below $100 for 128GB. It's a better iPod now than when it was new. The CF card upgrade gives it better energy efficiency, shock resistance, less weight, silent vibrationless operation, and no hard drive spin-up delay. It's a great sounding iPod (better than many newer devices), with an energy-saving always-readable screen. My ancient 4th gen iPod "classic" (with monochrome screen) is still working because I replaced its 20GB hard drive with a 64GB compact flash card on an adapter. When your iPod classic "gives out," the failure is likely to be the fragile hard drive. Instead of whining about a hopeless cause, take the initiative. When the light is magnetically connected to the bracket, the light automatically turns on. One half of the light is a bracket constantly mounted on the fork, whereas the other half is the light, which you can bring with you on the go. They would have to redesign it around flash-based storage, because the 1.8-inch hard drive is probably the key part that is no longer available. iflash One is a modern battery bike light. iFlash-SATA v10 (M. IPod is now ready to restore & sync using iTunes.If that was a good business decision, Apple would do it. iPod Classic iFlash mSATA 512GB SSD Modding - YouTube Heres some photos of my iPod Classic 7gen with Tarkans iFlash-SATA adapter and a 512GB SSD. Slide battery cable in to the connector and push down the black latch to lock the ribbon in place. Not shown – depending on the thickness of the iPod use the supplied foam pads to make sure the iFlash does not move in the iPod. Installation is complete, ready for the iPod to be closed. Install iFlash-Bundle in to the iPod, make sure the ribbon is fully home, then lock the black bar down. Insert and lock the SD card in to the iFlash-Bundle. After connecting it I got the sad face error message so I put it into disk mode and iTunes recognised it and I can restore it. iPod is ready to accept the iFlash board. iPod flash storage detected in disk mode but sad face error on boot I just used a SD to CF adapter along with a 1.8 zif IDE adapter to flash mod my iPod 5th gen. Remove all rubber bumpers and strips from the iPods if any remain after the HDD is removed. Gently lift the black bar to release the ribbon from the HDD. Rest the front and back side by side, be careful to not cause too much stress on the headphone ribbon. I suggest watching some iPod opening videos on the internet.īefore pulling the case apart, release the battery cable – lift the black lock bar -or- gently using even pressure pull up the battery ribbon away from the connector. Using suitable tools, release the holding clips, making your way around the case till it opens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |